RPi Zero W case with Official Rpi Camera V2 module

thingiverse

This is a remix of Wassupdoc's fantastic, minimalist RPi Zero W case. I slightly increased the height of the case to accommodate the official RPi camera module instead of the Picam. I made a cutout for the camera module PCB and widened the original channel for the Picam ribbon cable to fit the wider ribbon used in the official camera module. The ribbon is intended to be sandwiched between the camera module and the RPi board, just like with the original. I also created an additional backplate with a cutout for better access to the GPIO connectors. I haven't tried installing any headers on the board yet. Due to the increased height of the assembled case, the holder was slightly modified as well. Note: The fit of the pins is really tight, so be careful when inserting the RPi board. Also, the HDMI connector might be obstructed depending on your cable and connector. If you plan to use it, take this into account. The camera module will end up upside down, so remember to correct that in your Octopi settings!