RPi + PoE + GPIO extended pins

thingiverse

Remixed to fit RPi PoE hat and extended GPIO pins. I made this because I needed to fit the extended GPIO pins in order to be able to connect my touchscreen to the RPi as well as the PoE hat. Print the top case upside down with supports for the overhang The bottom of the case is the same as the original model. The standoffs (print 2) go between the RPi and the PoE hat on the ethernet side of the board, to ensure they are parallel. The other side is held by the GPIO extension pins. I suggest using a raft for these to avoid them coming off the bed I used M3x18mm screws to secure the top and bottom parts of the case together. The RPi doesn´t need any screws to hold it in place, it is a pretty snug fit once assembled. There is a small square cut-out where the 4 PoE pins are on the RPi, but it doesn't match up to the position of said pins. Since I don't actually have a need for those pins, I haven't fixed the cut-out. This doesn't affect the fit of the case. **This was designed for the older RPi PoE hat, I am unsure if it will fit the new model.