RPi Camera Cable Slot for Ikea Lack Enclosure

prusaprinters

<p>This is an insert for the Ikea Lack enclosure to pass a Raspberry Pi camera cable through the top.</p><p><strong>Assembly:</strong></p><ol><li>Layout the position of the insert on the intended surface with a pencil. Mark two points, 25mm apart.</li><li>Drill ¼ in. holes at the two marked points.</li><li>Remove the material between the two holes. You can use a utility knife for the Ikea Lack enclosure.</li><li>Apply CA glue and push in the insert.</li></ol><p>The camera arm in the picture is this one by <a href="https://www.prusaprinters.org/social/48769-marius-hornberger"><strong>Marius Hornberger</strong></a>: <a href="https://www.prusaprinters.org/prints/70840-modular-mk3s-camera-arm-also-rpi-hq">https://www.prusaprinters.org/prints/70840-modular-mk3s-camera-arm-also-rpi-hq</a><br><br>The RPi4 case is by <a href="https://www.prusaprinters.org/social/2964-stamos"><strong>Stamos</strong></a> and remixed by <a href="https://www.prusaprinters.org/social/15026-olivier"><strong>Olivier</strong></a> to include a slot for the camera cable: <a href="https://www.prusaprinters.org/prints/32179-raspberry-pi-34-b-case-with-slot-for-camera-cable">https://www.prusaprinters.org/prints/32179-raspberry-pi-34-b-case-with-slot-for-camera-cable</a><br><a href="https://www.prusaprinters.org/prints/24942-raspberry-pi-34-b-case">https://www.prusaprinters.org/prints/24942-raspberry-pi-34-b-case</a><br>&nbsp;</p>