RPI Cam Holder Bed mount

cults3d

https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner and the back-center. A M3-.50 nut is required. I remixed this, More or less just resized width in Cura and exported to accept the Raspberry Pi v2 Camera Module 8MP Camera. Should slide right in the groove. I originally printed this off and as it worked to a point, I had to mount it upside down because the slot was a little tight and I couldn't put the camera in the right way so the ribbon cable would extrude out the bottom. because the Inside was to tight, I had to file it down and still not quite there. So decided to just resize to 2mm more (32mm) width giving it more access to move around and install right without filing down the inside. So this should work for anyone wanting to use the 8MP Module v2 Camera by Raspberry.