RPI 30mm fan side mount

thingiverse

Note: I didn't create enough room for the sd card so I had to go back and trim out some of the plastic with a knife. Parts used: 8x M2.5x5 screw 4x M2.5x11 spacer 4x M2.5x5+5 spacer 30mm fan 4g HAT Raspberry pi 4B If I had to redesign the project I would find another way to do the sd card hole so that I could remove the card without removing the part. I might have made the screw holes too small I had to run a 3mm screwdriver through them so they were large enough for the screws. I had intended to use hotglue to hold the fan in place but it seams to stay up there pretty well once I press fitted it.