Royal Enfield 650 Turn Signal Indicator Bezel

thingiverse

Update on curved top prints: When I sliced in Cura, by default it centers the print on the bed. Suggest rotating it 30-45 degree so Cura doesn't leave a start/stop seam at the front of the rounded edge. (See last pic) The turn signal indicator in the tachometer on the Royal Enfield Interceptor 650 is barely visible at times, and I have a habit of forgetting to cancel my turn signal. Youtube video: https://youtu.be/C5XBp7gLl68 On the rounded print, there was just enough room to put a 28.5mm round volt meter (not enough room the the locking ring, so also had to put a little 5 minute epoxy to hold it in.) I Mounted on the speedo/tach with 2 sided 3M tape. For signal for the LED's, I spliced into the rear harness with some disconnects, and ran the wires under the tank up into the inside of the headlight. I was going to splice into the front indicators, but the inside of the headlight is pretty packed as it is. For the voltmeter, there is a keyed aux power connector (yellow) inside the headlight. I didn't want to wait a week or so to order the R.E. pigtail, so I just cut off the wires off as close to the connector as possible and crimped on my own pigtail with an additional connection for a USB socket or GPS. Note that the file names have either 6.5mm holes for a 5mm LED plus a plastic insert/holder, or 5mm holes for the LED w/o the insert/holder. All of the files will need some plastic safe glue or silicone sealant to hold the LED and/or 12v outlet/volt meter/usb outlet etc. All are held onto the tach/speedo with double sided HD 3M tape or similar. Just an F.Y.I., I am not very proficient at designing models so these aren't perfect.