Roxtec EZENTRY 10 Layout Template

prusaprinters

This is a layout template for Roxtec EZENTRY 10 electrical panel bulkheads. I had a recent project that involved cutting openings in a bunch of electrical panels and got tired of laying them out by hand. This was my solution! There are cavities for 12mm x 3mm round magnets, with a pilot hole for an M3 x 4mm flathead screw, under the faux bolt heads. The magnets are not strictly necessary, but they do make positioning a lot easier!Check out one of my other designs, "Bolt Head Fridge Magnet", based on the original magnet stanchions for this project.Please Comment, or post a Make or a Re-make! Thanks!Markings and Bolt HeadsTo get the raised copper markings and silver bolt heads required two filament changes. I started with Black Silk, which I swapped for Copper Silk at layer 9 (assuming a .2mm layer height), then switched to Silver Silk at layer 11.