Rotor Riot Flow Slammed Edition Parts

thingiverse

If you're building a Slammed Rotor Riot Flow and you purchased a GoPro mount with the frame, you've probably noticed that the mount was designed for the normal version and is stepped on the rear two mounting holes to accept the stacked top plates. This spacer simply fills the gap when using this GoPro mount on the slammed version of the frame. The stock camera plates caused the FPV camera to sit too far back in the frame, taking up a lot of my view with the GoPro mount and the top plate of the camera. These mounts allow you to move a full-sized camera up and out so that the frame doesn't block your view. The VTX mount was a quick way to gain some room for the battery wires and neatly position the antennas. It needs to be printed with supports because it sits flush with the bottom plate.