Rotating Flash Light Holster with detachable parametric holder

thingiverse

WARNING!! Belt Clip will break eventually. I've downgraded the belt part to a zip tie for now. Going to try to come up with something better. Here's my latest version of the Flashlight Holster, featuring a Fusion 360 File where you can customize two settings: * Flashlight Diameter * Magnet Box Width No supports are needed, just rotate the top and bottom so the flat part is on the bed surface. Notes below. With the flashlight in the clip, it helps keep it secured to slide, making it harder to remove the magnet assembly. If your flashlight isn't a perfect cylinder, you'll need to shim out the clip with washers between the ratchet and the clip (make sure not to exceed the ratchet circle if using metal washers). I managed to make the mechanism ratchet in both directions and stay stiff, but I haven't tested its longevity yet. It was an accidental discovery while trying to thread a bolt into it. That's why I prefer using a bolt-through method instead of tapping into the plastic ratchet. Tapping just doesn't feel right when you're pulling off the magnet assembly from your belt. Lastly, the magnet flap might be tight; strip some off if needed, it should be easy!