Rostock Max v2/v3 LED mount

Rostock Max v2/v3 LED mount

thingiverse

This design is a revised version of http://www.thingiverse.com/thing:1936202 . The original file did not allow enough clearance for the LED light with wires soldered to it to slide in at all. Affordable and effective, the lights used can be found here from BangGood: https://us.banggood.com/Wholesale-Warehouse-T10-5630-9SMD-LED-White-Light-Car-Canbus-Error-Free-Replacement-Light-Bulb-wp-Usa-989068.html . They are affordable and work great, with fast shipping as well! Simply solder one wire to each side of the LED and then slip them through the hole in the mount, routing the wires out of the side holes. If the wires are stiff coming through, just widen the hole a bit. After all of the lights are in place, clip them on to the rails at the bottom, then route the wires through the vent holes. Once the wires are routed, strip and solder three of the same leads together for each pole. Since these LEDs have no polarity, make sure the same sides are soldered together. Once you have two sets of three wires together, solder one wire to each to make the connection over to the power supply. Crimp a connector on the end of the new leads and attach one to the + and one to the - of the power supply where the case fan is attached, which is located inside the base next to the power switch and plug. Turn the switch on and you're done! If you have any questions about assembly, feel free to reach out to me at jwcproductions79@gmail.com .

Download Model from thingiverse

With this file you will be able to print Rostock Max v2/v3 LED mount with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Rostock Max v2/v3 LED mount.