Rostock Max v2 4 LED Insert for the LED strip extrusion clip remixed

thingiverse

This is an add-on insert for the LED strip extrusion clip remixed located here... http://www.thingiverse.com/thing:1231334. After attaching the four LEDs and soldering them together with a 100ohm resistor, I wired them to the FAN1 on the RAMBO board and use the command M42 P6 S255 to turn them on at the start of a print and M42 P6 S0 to turn them off when the print is complete. Later, I plan to add a switch to allow me to turn them on/off whenever I want. The LEDs are a bit tight to fit in but this is good since they won't fall out either. To make it easier to push the LEDs all of the way in, I used the top of a pen which I slide over the wires. Print Settings Printer Brand: SeeMeCNC Printer: Rostock MAX Rafts: Yes Supports: No Resolution: 0.2mm Infill: 100% Custom Section