Rosette

pinshape

Rosette faux stained glass prints upright, frame prints upside down, flip over and insert into upright frame after printing. To avoid confusion on these models, it's easier if you just remove one piece of glass at a time and glue into place. Print the frame with your normal profile. Print the glass using the following profile: three perimeters, two bottoms, zero tops, fifteen to twenty percent infill of your choice. For no pattern, use zero infill. I used to glue glass pieces in place with Acetone, but it's now unusable due to added residue and drying issues. I've switched to clear PVC ABS glue from the hardware store for a clean finish.