Rolling Pin Hanger

thingiverse

I was searching for an efficient way to organize clutter in my kitchen cabinets. Two rolling pins kept getting in the way by either sitting on top of boxes or tucked under them and the situation got worse when they were stored in those upper cabinets above the refrigerator. I came up with this hanger that can hold one or two rolling pins, which mounts to the inside of the cabinet (it must be a deeper cabinet, not 12"). I designed both single and double hangers. The cross piece helps keep them aligned and makes it easier to mount on the inside of the cabinet (or on a wall if you prefer). I used #6 screws to secure it to the wall. IF YOU'RE MOUNTING TO THE INSIDE OF THE CABINET, MAKE SURE TO USE THE RIGHT LENGTH SCREWS AND BE CAREFUL NOT TO DRILL THROUGH THE OUTSIDE WALL OF THE CABINET For a double hanger, you need to print two of the double end pieces and two of the cross pieces. For a single hanger, you need to print two of the single end pieces and one cross piece. The cross piece snaps right in place, depending on your printer tolerances, you might need to sand the cross piece a bit to make it fit flush.