Roller Damper

thingiverse

This noise damper is for 3D-printers. Most vibrations occur in the X- and Y-directions. The roller bearing turns these into very low frequencies. Hint: I think it would be better to use the "Oberes_Stueck_V2" as the most lower part (base part at table), too, instead of using the "Unteres_Stueck_V2" which should only be used once in the middle. ------------------------------------------------ This is a damper for 3D-printers. Most vibrations occur in the X- and Y-directions. Through the roller bearing, these are shifted into very low frequency ranges. Hint: I think it would be sensible to use the upper part also as the lowest part (lying on the table). This would likely be more stable. So, the "Unteres_Stueck_V2" would only be used once in the middle. I've got it like that now, just like on the photo. Let's see if this causes any problems.