Roll-up cigarette case

thingiverse

I'm attempting to smoke fewer cigarettes, so I set a goal of smoking no more than 4 per day. Unfortunately, carrying tobacco and filters with me to roll my own was necessary since I couldn't afford to carry pre-rolled ones. Therefore, I continued fiddling around in Openscad until this design emerged. Now I can easily roll enough for the day without going over my limit. The lid takes a bit of effort to attach, but after attaching and detaching it several times, it works flawlessly. Given that I designed it slightly too small, printing it 10 times its size is necessary. You'll also find the OpenScad files here in case someone wishes to make any changes. For my part and for now, this will do. edit: No rest until perfection was achieved! The entire design has been remodeled completely. Scaling shouldn't be necessary anymore, and the corners look significantly better. I'd love your opinion on its printability. again edit: Another version emerged as I reviewed v2 and realized I had enlarged the smaller corner radius far too much in that model. However, when I did so in version 3, the available material became alarmingly thin. To avoid making this worse than it already is, I will test both v2 and v3 in real time by adding them to the design page and publishing new photos for all your review!