Rocking Stand

thingiverse

https://www.thingiverse.com/thing:4441076 reduced the width by 15mm and increase the length by 10mm to suite stretched X, repositioned the rear support to accommodate more bottom battery configurations. This remix will require you to use 2 x 25mm bulldog foldback clips with an adhesive back foam tape suck in the middle of the clip to keep it a bit off the rail to be able to adjust the position for different drone configurations (true X or squished X) to achieve the ideal C.O.G on the stand. For stretch X you don't need them so I just clip them to the back out of the way. All credit to J.Nimbl for the original design! Thank you Requires: 1 of each except for the bearing retainer (x4), Pivoting Cross Support-15 (x3), Rocking Stand Brace Cross Brace (x4). 20 x 20mm counter sunk M4 screws (Hobbyking), 20 x M4 nut (anywhere - but not locknut, advised to use CA. And use a torch lighter to get them into the braces if you are struggling).