'ROCKETZ'... Interlocking Storage Stages and Fun Model

thingiverse

ROCKETZ are a five-part interlocking model of a cartoon-style rocket. The lower four stages serve as storage compartments, and the top capsule functions as the cap for the stage below it. Refer to the images for additional information. The largest storage capacity stage is located at the base (engines), with each subsequent stage reducing in capacity. The total height of ROCKETZ is 235mm when all stages are fitted. Be creative by printing ROCKETZ in your chosen colors or printing different stages in distinct hues. Each stage locks together by aligning the lugs with the opposing part slots, pushing the parts together, and rotating 120 degrees to secure them in place. This enables you to carry your ROCKETZ without worrying about it falling apart. It also allows you to access a single stage to add or remove items without opening the other stages. ROCKETZ will require time to print, but they are well worth the investment of plastic and time. The result is a unique model that can be used to store various small items, such as Lego toys, nuts, bolts, screws, electronic parts, and components. The stages are easy prints, with no support required. A raft is recommended for the engines and capsule due to their reduced contact area with the build plate compared to stages 1, 2, and 3. The joint clearances have been intentionally left slightly loose to ensure that most machines can print ROCKETZ without issues and interlock correctly for use. If you want to uniformly scale down ROCKETZ by 10%, it should be acceptable; however, scaling it down further may reduce the clearances too much, causing the stages not to interlock. Please refer to the print settings and images for additional information, and post your pictures of ROCKETZ in action. This is a fun version of my Interlocking Stackerz found at http://www.thingiverse.com/thing:1546446. Note that if you like this design, be sure to check out the rest of my fun and practical designs. Print Settings: Printer Brand: MakerBot Printer: MakerBot Replicator (5th Generation) Rafts: Yes Supports: No Resolution: Standard / 0.20mm Infill: 2 shells / 15% or more infill recommended Notes: Easy prints in PLA... printing all five stages takes time, but the result is worth it. This is a unique fun model and practical storage system in one. Post-Printing: Assemble and lock the parts together... Assembly is straightforward; simply insert the upper stages into the lugs of the stage below them and turn 120 degrees to secure them in place. Please note: Stage 2 will fit into the Engines stage but may not look correct or be a proper fit.