Rocket Ship Blast Off w/ Smoke

thingiverse

I stumbled upon this post on Reddit and decided to recreate it myself since the original creator took down the design - https://www.reddit.com/r/3Dprinting/comments/dk0uyi/space_rockets_lift_off/ I designed the entire project in Tinkercad using the pictures from the post as a guide. As I write this, I haven't printed it yet, but there's no reason why it shouldn't print flawlessly. Make sure to use supports for all overhangs, including the leg arches, the ship's center section, the larger of two bubbles on the ship (the smaller one might not need them), and the disks on top. The smoke has a post that should fit into the hole at the bottom center of the ship. I'd weigh it down so it doesn't tip over by either using 100% infill or placing weights inside the smoke bubbles while it's printing. I'd also print the rocket with low infill to reduce weight, probably 10% or less. If you end up printing this design, post a make and good luck!