Rocker Switch Panel XT60 mount

thingiverse

This is a universal XT60 mount suitable for both male and female connectors that utilize an M2 screw (25mm) to secure them firmly. To use it effectively, you need to position the XT60 connector within the mount and drill a small hole through it without worrying about the terminals touching or causing a short circuit if done correctly. The M2 screw extends from one end of the mount to the other, providing a secure hold on the connectors. Meanwhile, the adjustable arms swing outwards to prevent the 3D printed part from escaping through the rocker switch opening. Two M2 screws and two M2 nuts (one set per arm) are required for assembly. While the arms provide good grip, it's still possible to remove the XT60 connector with some gentle wiggling when disassembling. So far, I haven't experienced any issues with the mount coming loose from my rocker switch hole. Interestingly, no adhesive is necessary at all for this setup.