Robust tablet holder for DJI Mavic controller

thingiverse

Extender for holding a tablet on the controller for DJI Mavic Air 2s. Probably also fits to DJI Mini 2 and Mavic 3, but it is not verified. Tablet size 8" verified. Probably fits up to 10". #### Versions Holder base v2 versus v1: opened back side or not. Also the base retainer v2 a bit shorter. Printing the base v2 will require more supports from the table. I don't think that's a problem. I didn't print v2, but I think this version is better. #### Printing disclaimer You must have a well calibrated printer including correct flow setting for the filament which you suppose to use. The printing tolerance is **0.15mm**. If you're not sure or didn't understand what I'm talking about - don't waste the time to make this thing. Or don't blame me after, that _your_ printed parts don't fit together. Also in some cases you'll need to use the tools (needle files for corners, drill bits for holes and etc.) to reach the best result from the printed model. Especially if use don't use Linear Advance or similar algorithm. You shouldn't expect that the model will be fine immediately from the printer. At least not always :) ### Source The source is [here](https://cad.onshape.com/documents/c17c0792b6d1541913458128/w/9f02fce7a88ab04d82a4081c/e/f5adcb356c2a0a17191afc51). There is only v2 active now. If you need v1, see in the document history. Probably it's makes sense to make the walls thinner. You can change it in the source, there is a special variable.