[RobotGeek V.2] ArmLong- Robot Arm Mod (2016 Science Olympiad)

prusaprinters

<p>This is a very simple, in line, Robot Arm extenders that fit onto the RobotGeek's V.2 Robotic Arm for the 2016 division C Science Olympiad. It should be fully rules complaint but check dimensions before using this design.</p> <p>The Armlong will adds 9.5 cm of length to each segment of the robot it is attached to (19 cm as pictured). These parts require no modifications to the robot's frame and only requires 16 additional M2x10 bolts and nuts. Servo wiring extensions may be required.</p> <p>Design Project: Project Star Knight</p> <p>====================================================================</p> <p><strong>Printed Parts needed:</strong></p> <p>4x RobotGeek ArmLong</p> <p>====================================================================</p> <p><strong>Hardware Needed:</strong></p> <p>16x M2x10 Bolts https://www.amazon.com/gp/product/B00O9Y3ATG/</p> <p>16x M2 nuts https://www.amazon.com/gp/product/B00BG8TFR4/</p> <p>====================================================================</p> <p>Note: At time of upload, the design has not been tested in competition and has no guarantee of performance.</p> <p>Also as Noted by <a href="/robotgeek_official/about">RobotGeek</a>:<strong>All extenders will add stress to the servos. Use at your own risk. I am not responsible for any damage that may occur. Use cautiously as this may burn out a servo(s) which may not be covered under the warranty.</strong></p> Category: Engineering