Robot Lawn Mower by ReP_AL Large parts to fit 235x235mm bed

thingiverse

Thanks to ReP_AL for his dedication, time and effort put into this project. This has been a very rewarding experience for me so far. Check out his website here: https://repalmakershop.com/ The mower was designed to fit a 300x300mm printer but since I have an Ender 3, my maximum build area is only 235x235. I had to cut the large parts down to size. Note that these are not original parts! The holes may be different sizes and they might need sanding, drilling, gluing or a big mallet to assemble! The frame could use a better design in my opinion. I used dovetails but I think it would be better with a tongue and groove type cut. However, mine is already assembled and I haven't had the time or need to redo it yet. The back fascia holes didn't line up with my MEGA board (it's known that these boards have small variations in the locations of the screw holes). So, I moved them to fit. The two halves are simply joined together with m3 screws and nuts. I included parts that accept 40mm fans. The original design uses smaller fans. Also, I included the blade disc and rear wheels that use off-the-shelf adapters. Here are the adapters I used: Blade disc: https://www.pololu.com/product/2693 Wheels: https://www.pololu.com/product/2687