Robocop Bust Improved (With Stand)

thingiverse

Available exclusively to my loyal Patreon supporters, I'm afraid not everyone can access this premium content just yet.\nMy other Robocop bust had always bothered me with its poorly positioned lips in the helmet; they looked all wrong. On top of that, I wanted to print the OCP logo alongside it, so here's a brand-new version, boasting higher resolution (though slightly decimated) and conveniently split into three sections for those who want to scale up.\nRegarding the lenses, I highly recommend printing them with two or three perimeters/shells – the current design is on the thinner side, but it works fine. In fact, another similar bust is in the pipeline, inspired by my previous Darth Vader model.\nThis latest version boasts an entirely new head interior, featuring lips that are more accurately shaped like Peter Weller's iconic portrayal of Robocop. And if you print at 0.15mm resolution, the font on the side of the helmet should come out perfectly legible.\nI successfully printed mine in three separate pieces without any support material – a feat I achieved even without cooling or using ABS plastic. However, for those without cooling capabilities or printing with ABS, I strongly advise using supports on the chin section to avoid potential issues.\nTest prints have been completed on my trusty Kossel Mini 3D printer at a resolution of 0.15mm, taking approximately four hours to complete with print settings set to 80ms feed and 250ms travel speed. The model was printed in white PLA plastic, sanded down, and primed with matte black paint – ready for the final touches.\nPlease note that this model and any printed replicas are strictly not for sale or profit distribution.