RoboCat Multicopter RunCam Holder

thingiverse

To attach a RunCam to your RoboCat Copter Frame, you'll need this special Plate. Simply print the Plate, then carefully place the camera on top of it. Before securing the camera in place, make sure to heat up the pins slightly so that they can hold the camera firmly. Print Settings: Printer Brand: Ultimaker Printer Model: Ultimaker 2 Rafts: No Raft Required Supports: None Needed Resolution: 100 Microns for High Detail Infill Density: Set to 100% for Maximum Strength Important Notes: To ensure a smooth flight, the infill should be at least 20% to prevent vibrations. Alternatively, you can print it as solid for added stability. The material required is approximately 25cm in length.