Robocat lowrider Mk1.

thingiverse

Robocat 270 lowrider mod. Features 25mm standoffs and HS1177 cam. Includes a hole in the back for vtx antenna installation. Future modifications will allow further lowering when shorter standoffs are acquired, aiming for an ultra-low profile. Initial design oversight resulted in missing holes under the front, necessitating a drill to rectify this issue. Additionally, screw head clearance is slightly off, and can be adjusted with a hobby knife. A more thorough review prior to publication might have avoided these minor flaws; however, expediency took precedence. Print Settings: Printer: Fabrikator mini Rafts: No Supports: Yes Resolution: 0.2mm Infill: 100% Notes: To ensure a smooth print process, the rear section should be printed upside down without support. This allows for a faster and more efficient print cycle. The front section, however, requires printing upside down with extensive support due to its complex design. While it's possible to print the front right-side up, this approach would necessitate additional support structures, significantly increasing the overall print time.