ROBO R1 Dual Fan Duct Cooling System

thingiverse

I have just made a new change to the fan duct so that when screwed into place it sits further from the build plate. I noticed that the corners had a possible tendency to touch the plate, which may require some filing to fit. Part cooling is being upgraded for printing better bridges and overhangs. This remix of TechsupportGo's mount includes minor changes to the design and to the print itself. The rear shroud has been cut shorter so that none of the plastic comes into contact with the heater block. On my printer, it is actually the front shroud that needs to be adjusted because of how I have it set up. As a result, your part will not slowly destroy itself by melting on the heater block as you print, especially when using high-temperature filaments. See instructions for printing recommendations and hardware list.