Robo-Chain Connector für Ultimaker Robots

youmagine

With this easy-to-use connector, you can link up all your Ultimaker robots seamlessly. I designed it to repel these pesky little guys from my desk with ease. When attached to a chain, the robots even seem to be content (just look at the red one). Each link features two ends that easily connect to another one. You'll also need start and end pieces to secure the chain on the wall using pins or small nails. However, I must issue a warning: this print is not for beginners. A tiny rotating joint is located at the hook where the robot attaches. When printing too hot, this joint will fuse together permanently, making it useless. To avoid this, I printed at the lowest feasible temperature. PLA filament worked best between 185°C to 200°C, depending on the material. A layer height of 0.1mm ensured a smooth finish.