Robo 3D 2004 LCD Swivel Riser Feet

thingiverse

Another Remix of my initial design for a SainSmart Full Graphics LCD. Check out the RepRap Full Graphics LCD Remix at http://www.thingiverse.com/thing:1773140. This version is specifically designed for the 2004 LCD Controller, so be sure to print it in the same orientation as the LCD Case. Supports are required for the LCD Back, but only a few strategically placed ones will do the trick. If you're slicing with S3D, focus on adding supports under the part parallel to the bed and a few more to support the swivel. The LCD Front can print without supports unless you flip the orientation, in which case some may be necessary. The Robo logo should print just fine without any extra support, but you might need to tweak your bridge settings. Take a look at the layers before printing to ensure the logo will turn out as desired. I've printed a similar version with this logo and had no issues; in fact, it looks great thanks to the visible bridge lines. Please note that this case was designed around a 2004 LCD Controller from GrabCAD (https://grabcad.com/library/ramps-2004-lcd-prusa-reprap-screen-1-4-1). Since I don't need this Case myself, I'll keep working on it until someone prints and verifies everything fits together properly. The only version of this design I haven't remixed yet is the XXL; let me know if you'd like that one and I'll get to work on it. Don't forget to Like and Share your Make! Post-Printing Hardware: (1) 2004 LCD Controller with Cables (of course), (4) #10 - 1" Long Rounded Head Screws, (8) #4 - 1/2" Long Flat Head Screws