Rivian R1T/R1S Phone Holder

prusaprinters

<p>A while ago, when Rivian first started delivering Rivian R1T trucks, there were complaints about the wireless phone charger not being grippy enough to keep a phone in place while also charging. To prevent this problem, I designed this bracket that should fit a RiT Center console however was using crude measurements and pictures from the internet since I've never actually seen one of these in person. Because of this, I am open to any changes that should be done in order to make sure this fits.</p> <p>To assemble this, you will need two small rubber bands to hook around the hooks on the two pieces. This will allow phones of any size to fit well. Since the bracket is so wide, it will still be very easy to remove your phone.</p> <p>There are two pegs on the bottom of the design meant to keep the bracket in place, however, I would recommend putting a piece of tape along the inside of the bracket and the divet in the center console.</p> <p>I will be updating the file for this thing if any suggestions come in to make the bracket fit better.</p> <p>I have signed legal documentation stating that this design is mine, so please do not try to profit off this design.</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div> <p><strong>Infill:</strong></p> <p>0.35</p> </p> Category: Automotive