Rival Zeus Vector Body-kit (Prototype)

thingiverse

UPDATE 12/11/2018- Files are confirmed as fitting and working perfectly! Some changes have been made since the original but hardware remains the same for screw size (M2 Countersunk) if you do choose to use a different type like button-head, let me know how it goes! NEW FILE- Name Plate Designed to fit into the section on the left body-plate, can be left blank but its there for you to put your own logo/name/design for customization! Make it your own! --------------------------------------------------------------------------------------------------------------------- UPDATE 9/11/2018 - Full file redos are up, parts should be better matching now. Muzzle details added. UPDATE 6/11/2018 - I have simplified the design of the muzzle adapter and made the connection between it and the Inner hand grip much more simple based on feedback. Added tolerances in of 0.5-1mm to ease onto the blaster better, bottom connector will be added after testing to make sure lengths are correct. UPDATE 1/11/2018 - Due to feedback regarding handle adapter files are down until a fix has been done, thanks in advance for your patience and for your interest! UPDATE 3/11/2018 - V2 Files for the front, hand grip, sides and handle connector The first stage prototype kit for the Nerf Rival Zeus Blaster is finally here! I have been working on this for a few weeks now as a passion project and this is the 1st full prototype. The kit is designed to be held together by M2 countersunk screws (4-8mm,2x25mm and 2x20mm), I have tried my best to make it as material friendly as possible while still hopefully retaining enough strength to withstand play. All parts have a fairly obvious side that's designed to be on the printer floor, and it should be fine to print in PLA, although I do not have a printer to test this. If anyone does wish to test this and would give me feedback so I can alter the design to better fit that would be a huge help for future modeling! Quick (theoretical) Set up 1- Remove the blasters front iron sight and bar that holds it. 2- Slide on the front "Barrel" Attachment 3- Secure it with the top pin (near where the iron sight was located) and lock in with a M2 Countersunk screw (4-8mm should work fine) 4-Attach the slider part to the inner grip section with 2 x 25-30mm M2 Countersunk screws 5-Side the grip on and secure with one 4mm screw via the front of the barrel 6-Attach the left and right grip panels using 4-8mm Screws 7-Slide in the bottom connector and connect via side rails using 8mm screw the parts 8-Remove 2 lowest screws on the blasters handle 9-Slide on the handle connector and use the 25mm screws to secure the part onto the handle 10-Screw the handle connector to the bottom connector using 4mm or 8mm countersunk screws NOTE-Some parts may require minor sanding, however I hope my measurements are accurate enough that they shouldn't. NOTE #2 - Assembly file IS NOT for printing, its just to show the assembled parts. Note#3- Apologies for the weird image, I had screenshot it but I have no idea why it came out the way it did.