RiteWing Nano Drak Vista Holder

prusaprinters

<p>This is a mount that holds the Caddx Vista mount that I designed (you can find that <a href="https://www.prusaprinters.org/prints/105484-caddx-vista-mount">HERE</a>).</p><p>To install it, cut off the nose of your Nano Drak (I know, it's nerve-wracking!) right where the grooves for the spars end. Make sure you get it nice and parallel to the firewall. Then just glue the mount right to the flat spot that's left on the nose. Run two wires back to power, or four wires if you want to connect to a flight controller. I use a PH2.0 connector close to the Vista, then you can jam the connector in the space behind the camera and it fits nice and flush.</p><p>Yes, the Vista protrudes from the nose. I had to cut the sides down to give it proper ventilation (not an issue in flight, but I burned up two Vistas on the ground working on this design).</p><p>Enjoy!</p>