Riser stand for darkOne tray with FrSky X12S TX

prusaprinters

<p>The tray riser prevents TX connector/cable damage during programming of FrSky 12XS with darkOne TX tray.<br/> As the tray original rear bottom supports are only glued to the base, there can be dimensional inaccuracy. The raiser left and right parts are fixed by click-on to the tray alu tubes, not to the bottom supports, there must be enough space for the supports to fit in freely.<br/> You can either print a draft prototype, test and modify the source, or (quick and dirty) print as is and fine-tune with a deburr tool.<br/> Not intended to fit in the TX transport case when attached.</p> <h3>Print instructions</h3><p>Infill 15%<br/> Support on build plate only</p>