Ring Stacker for Babies

pinshape

My first upload here is a simple yet colorful ring stacker perfect for young children. I created it specifically for my 11-month-old, who absolutely adores it. You can print the rings in any color you prefer - the colors shown are what I used, with a glow-in-the-dark purple base. The rings spin smoothly and fit snugly on the pole, while also being easy to remove. Print Settings: Printer: DaVinci Jr 1.0 Rafts: No Supports: Yes Resolution: 0.2 Infill: 30% Important Note: I recommend using supports for the rings as they can be a bit messy on the bottom side without them. For added strength, you may want to adjust the infill percentage based on your needs. Post-Printing: After printing, take a moment to clean up any excess material from the bottom sides of the rings. Also, inspect the inner holes for sharp edges that could pose a risk to little fingers. As a precautionary measure, double-check all prints for any sharp edges or parts that may cause harm. Please use your discretion and print at your own risk.