Ring Stacker for Babies

thingiverse

My first upload ever! A simple yet vibrant ring stacker perfect for young children. Created it especially for my eleven-month-old baby, who just adores it. You can print the rings in any color you like - I used those colors shown in the picture, with a glow-in-the-dark purple base that really shines. The rings spin smoothly and fit securely onto the pole without any issues. This design is compatible with 150x150x150 beds. Print Settings: Printer: DaVinci Jr 1.0 Rafts: No Supports: Yes Resolution: 0.2 Infill: 30% Notes: I strongly recommend using supports for the rings, as they can be a bit messy on the bottom side without them. I use a 30% infill to make them slightly stronger, but you may want to adjust this setting according to your needs. Post-Printing: After printing, take some time to tidy up the bottom sides of the rings. Also, inspect the inner holes for any sharp edges or points that could harm little fingers. It goes without saying that you should thoroughly check all prints for any potential hazards before letting children use them.