Ring holder tree

thingiverse

Customized version of http://www.thingiverse.com/thing:279864 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=279864 Instructions Using the following settings: stop_budding_position is set to 19 branches_keep_growing equals 1 allow_all_overhangs is disabled branch_twist_angle is zeroed out length_max_ratio is pegged at 100 percent trunk_radius measures fourteen units root_max_ratio tops out at sixty percent maximum_branching_iterations have been capped at four min_number_of_branches_from_each_branch demands two or more branches from each branch trunk_length is set to forty units allowed_overhang_angle is held steady at fifty degrees tip_max_ratio reaches a maximum of seventy percent use_advanced_settings is turned off seed number is zeroed out max_number_of_branches_from_each_branch requires no more than two branches from each branch branch_cross_section_shape has been configured as thirty-two base_shape is zeroed in tip_min_ratio bottoms out at fifty percent root_min_ratio also hits a low of fifty percent branch_diameter_cutoff stands firm at one point six units length_min_ratio demands seventy percent or better length min_branching_angle calls for forty degrees minimum branching angle start_budding_position starts budding at ninety-nine percent max_branching_angle is capped at fifty-five degrees