Ring Doorbell Pro Offset

thingiverse

This simple offset for the Ring Doorbell Pro does its job without any unnecessary bells and whistles - it's just a plain box that creates space for the doorbell. I tested it in PLA, but ABS is the better choice if you plan to use it outdoors. To print this design flat on its back, you won't need any supports for the screw holes. The box has two screw holes in the back and one hole for the wires. My wires were just long enough to reach, but yours may be too short, so you'll need to extend them. There's a small gap once installed due to the fins on the back of the Ring doorbell itself, but this gap can easily be filled with caulk or foam.