Ring Alarm Base Station Stand

thingiverse

After dropping my Ring Base Station one time too many, I decided to give my ADT Pulse Hub Stand a quick makeover to hold the Base Station securely. I aimed for something functional rather than flawless when creating this mount. The print was laid flat (25% infill), but that's a lot of filament with the supports involved. If you're mounting to the back using screws, make sure the Ring alarm's base rests on the bottom of the base instead of hanging from it. In the photo, you can see I added tape over the back of the screws because I needed to remove them to grind them down. I hope this DIY solution helps anyone until a better design becomes available. Thanks!