Rigol 1054Z / 1074Z / 1104Z Replacement Foot

thingiverse

The foot on your Rigol 1054Z oscilloscope broke, so print a new one that fits in minutes. This replacement is a bit sloppy but will lock into place. Print this part at 0.05mm layer height (Ultra Detail) using PLA. It needs supports to avoid sagging in the detents. I adjusted settings: Overhang Threshold to 90 degrees, Pattern to honeycomb, reduced Pattern Spacing to 0.5mm, and disabled Don't Support Bridges. Print it flat on the bed for maximum pivot strength. Fitting the new foot takes a few steps. Remove four Torx screws from the 1054Z - two small ones near each foot and two larger ones hidden behind the handle. You don't need to fully remove the back panel, just separate the front and back panels enough for the feet to pop out. The feet are sandwiched between the panels and can be easily removed.