RigitBot Hex Key Holder

thingiverse

It's just a simple storage compartment for those three hex keys that came bundled with the printer. The sliding tray slides downward, allowing access to the spool holder mounted vertically. Since the print setup is inverted, prints can be produced upside down without any fuss. After loading the design files sliced by Cura into the printer via USB, this job printed just as it should have, devoid of any unique aspects or quirks. A tiny printing anomaly was discovered, where the smallest hole appeared partially closed upon contact with the nearby build plate. However, to gain access to these blocked areas, heat one end of the hex key with a lighter, and gently press it through from underneath. A small amount of gentle force will do just fine; in fact, letting the melted plastic gradually push its way into position may actually prove easier than trying to apply force directly. Continue rotating until the plastic fully hardens once again.