(right side) Wanhao Duplicator 6/Monoprice Maker Ultimate Mount for Logitech C922

prusaprinters

<p>This is effectively the same model as “<strong>Wanhao Duplicator 6/Monoprice Maker Ultimate Mount for Logitech C922 (left side)</strong>” but designed to fit on the right side of the printer as spacing is a bit different there.</p><p>Quote from the original post, as this is essentially the same model for a different side (with a few tweaks to the positions and sizing as the right side of the printer has slightly different spacing) :)</p><blockquote><p>This is made to use as much of the camera's original hardware as possible with only minor disassembly required (do this at your own risk).</p><p>The camera has a little kickback platform at the end of the base where it can connect to a tripod. It's possible to disassemble the tripod mount (3 screws total – two easily visible and one inside of the tripod mount). The little kickback platform has two plastic inserts that allow it to swivel. These inserts can be taken out of the stock part and inserted into this mount and then screwed back together into the tripod mount assembly for a secure fit.&nbsp;</p><p>For my build, I also coated the outside of the part that houses the plastic hinges in a thin layer of CA glue. That's one of the most fragile parts of the mount and will separate easily along the layer lines with a little bump of the camera. So adding just a bit of glue before installing gives it just a bit more strength than just raw plastic.</p><p>The camera ends up being mounted upside down but most software should allow for the image to be rotated the right way up.&nbsp;</p><p>Also, I designed it for C922 specifically, but looking at some of Logitech's other cameras it looks like the same mount mechanism may apply to some of their other cameras.</p><p>&nbsp;</p><p>(P.S. One of the photos showing how the plastic hinges fit into the model is of the old (less sturdy) version of the design)</p></blockquote>