Ridgerock Danchee Body Rokker V2

cults3d

This body can be directly bolted onto the original Danchee rock slider/body mount brackets. Remove the original brackets, bolt on body. That easy! Steps: Remove original Danchee body. Remove original rock sliders/body pins from the frame. Bolt body bracket onto side panels, with the flat sides on the same side using 3 M3x8mm bolts per side. They should self tap into the side panels. Using the M3 screws removed with the original brackets, bolt each side panel to the frame with the spacers in between the body bracket and the frame. You will be using the existing holes that the rock sliders used. Place the center of the body in between the side panels. Using M3 bolts, place a bolt through each hole in the side panel into the corresponding hole in the body center peice. Tighten all screws slowly by alternating each bolt one turn each. This will ensure you are not creating too much heat with friction which may strip the hole on the center panel. A lightbar may be installed in the windshield, but may impeed the installation of a full size stick battery.