Riddler Trophy - Batman Arkham Asylum

thingiverse

I desperately wanted one as soon as I laid eyes on it - the official Batman Arkham trophy prop is incredibly iconic in the entire franchise. But, unfortunately, it was both expensive and extremely hard to find when I first saw it. Later, I finally got around to modeling a replica of the trophy and printing one out for myself. My creation may not be the most elegant or optimal way to build one, but it's exactly how I managed to get it done. The design is specifically intended to utilize stripped elwire that runs through channels in the question mark shape. There's also a compartment underneath to store any necessary electronics and a pathway to route cables from the compartment to the lamp holder. If you're curious about stripping elwire, be sure to check out this short video I took some time back. VIDEO: https://youtu.be/ahcQ8vJMmAA If you decide to follow along with my project, here are some materials that I highly recommend: El-Wire Green - https://amzn.to/3btooTQ PLA Green - https://amzn.to/2JmqybM PLA Silver - https://amzn.to/3dzTFq4 Raise 3D Printer - https://amzn.to/3aqoH1t Soldering Kit - https://amzn.to/2UCexnU Acrylic Paints - https://amzn.to/39mLNFc Bob Smith Super Glue - https://amzn.to/3aqG5Dg When printing the base, I highly recommend printing it with high infill and perimeters. Maybe go for 30% infill so it's heavy and less prone to being knocked over. Some minor aesthetic improvements were made to the design since some of the photos were taken - nothing major, though.