Riddler Trophy Arkham

prusaprinters

I got Inspired by TomSmithCreations Trophy but when I printed it out I had trouble assembling and printing the trophy (Supports were a pain to remove) so I went back to scratch and remodeled the entire thing to be printed without supports and assembled in very little time.   Uses Green EL wire in the question mark that then runs down into the base. a bit of heat shrink covers the wire between the top and base. The top alignment pins go in the top 2 bits to, well align them together I would recommend concentric surface for all the prints, except the main body. and you don't need much infill. I printed the question mark completely hollow The little arms that hold the Top up are quite weak so i designed them hollow to fit a 1/16" or 1.6mm Rod in them for a bit of extra strength. I had Brass rods on hand so i used them. Here's Toms original one: https://www.thingiverse.com/thing:4245103