Ricoh Theta Compact Arca Tripod Plate [UPDATED]

prusaprinters

Note: The original version of this design did not work in some arca clamps because the wedge part was both too wide and not tall enough. This version should work with most tripods. Leave a comment or post a remix if you have any issues! Thanks This is a very compact arca-type tripod plate designed to fit the Ricoh Theta SC, Theat V, or Theta SC II. It probably will fit the older Thetas as well, but I don't know much about them - If you're able to print a copy and give it a try, please leave a comment! The plate includes a wrist strap connection point and a hole big enough for most usb cables, so you can charge it without taking the plate off. Why they designed these things with the port on the bottom and with no wrist strap connector is a mystery to me, but here's a solution. I've tested it with these screws: https://www.mcmaster.com/92220A181/ Just get a 1/4 20 screw that is about 1/4" long, with a head no wider than 0.375". ⚠ Disclaimer! Use at your own risk! I have been using 3d printed tripod plate + strap connector combos for years with no problems, but ultimately the safety of your gear is up to you, and I take no responsibility for any damages caused if your copy of this design breaks or does not work with your gear. Category: Camera