Ribbon cable clip and Bltouch wires cr-10s pro

thingiverse

Here's a quick DIY solution I came up with that I think you might find helpful - a guide for wiring your blTouch along the ribbon cable on my CR-10S PRO printer. The idea was to create a simple way to manage the blTouch wires, and here's how I made it happen: I printed five of these clips and spaced them about 15cm apart along the ribbon cable. Simply slide in the ribbon cable and squeeze - click - it closes firmly and stays that way. Next, run your blTouch cables through the smaller outer holder. I found using a scraper to gently pry open where the blTouch wires go made it easier to insert them. In fact, I discovered it's even better to install the blTouch wiring first, then attach the clip to the ribbon cable - much more straightforward that way!