RGB Rotating Display Stand Arduino

thingiverse

The build video is scheduled for tomorrow, March 25th, 2018. You can check it out here: https://youtu.be/6Y1cm4pIf8M. The filament used in this project was ecoPLA by 3dJake. Check out the product page here: https://www.3djake.com/3djake/ecopla-transparent. Here's a link to the Falcon model that was used in this build: https://www.thingiverse.com/thing:919475. I've also included information about the Arduino kit I mentioned earlier, which can be found here: https://www.banggood.com/UNO-Basic-Starter-Learning-Kit-Upgrade-Version-For-Arduino-p-970714.html?p=CS101558118042016088&utm_content=huangguocan&utm_campaign=mesh.drone. Additionally, I've listed the stepper motor and driver used in this project: https://www.banggood.com/28YBJ-48-DC-5V-4-Phase-5-Wire-Stepper-Motor-With-ULN2003-Driver-Board-p-74397.html?p=CS101558118042016088&utm_content=huangguocan&utm_campaign=mesh.drone. Here's a link to the led ring used in this build: https://www.banggood.com/1PC-8PCS-12PCS-16PCS-24PCS-Round-Shape-WS2812B-SMD5050-RGBW-RGBWW-4-In-1-LED-Light-Chip-Board-DC5V-p-1202247.html?p=CS101558118042016088&utm_content=huangguocan&utm_campaign=mesh.drone. The Arduino nano used in this project can be found here: https://www.banggood.com/ATmega328P-Nano-V3-Controller-Board-Compatible-Arduino-p-940937.html?p=CS101558118042016088&utm_content=huangguocan&utm_campaign=mesh.drone. Finally, I've included a link to the 3D printer used in this project: https://www.banggood.com/Tevo-Tarantula-Prusa-I3-DIY-3D-Printer-Kit-With-Auto-Leveling-Sensor-200x280x200mm-Large-Printing-Si-p-1175940.html?p=CS101558118042016088&utm_content=huangguocan&utm_campaign=mesh.drone.