RGB LED leaping arch

thingiverse

Still gearing up for Christmas is my current focus! Just completed finishing up my "Leaping Arches" today. Each arch has a diameter of 160 cm. For the LED display, you'll need to source WS2812B LED strips. Specifically, use two 30LEDs/meter strips placed in parallel with each containing 78 LEDs. Check out this project in action here: https://www.youtube.com/watch?v=d1EKWa41jqU Instructions for assembly are outlined below. Printing is necessary for the creation of 15 bottom and top parts, with an estimated weight requirement of 1.4 KG PLA per set. Connect all assembled components together using M4 bolts, nuts, and washers, which can be secured with 12 mm long hardware. A total of 56 such fasteners will be needed. Next, add a 78 LED WS2812B LED strip to the top arch section and another to the bottom arch section. Once installed, apply adhesive to secure these components in place. As for the top parts, they have been glued in place except for two outer sections that can be detached if necessary wiring adjustments need to be made.