Rey's Staff

thingiverse

I built a model of Rey's Staff after waiting to make her staff for a while until I got my printer. This entire model is centered around a 21.5mm diameter pipe that I already had, so keep that in mind when printing. The model consists of 29 pieces, each piece featuring notches on the inside hole at the bottom to indicate which piece they are, except part 1 which has it on its top (these may be easier to see on different printers but were still visible on mine). Some pieces in the middle (mainly 11 through 16) can be omitted if you want to lengthen the staff or save on filament as these are slightly thicker than the pipe, providing a good guide for wrapping materials after printing. A number of pieces require supports to print correctly, but when printing vertically I recommend that only pieces 8, 10, 17, 18, 19, and 23 have support touching the build plate. Piece 1 is the base piece (it's not always clear which end is the top in pictures), so I suggest building up from there in order of piece number, with the notches serving as a helpful guide post-print if needed. My print was done on an Anycubic i3 Mega, with a 0.2mm layer height, varying supports, and in Silk Grey PLA by Stronghero 3D. Happy Printing and Cosplaying.