Revo nozzle E3D box

cults3d

Español: In this box you can store 4 Revo nozzles in a small space. The closure is magnetic thanks to the use of 8 small magnets:5mm diameter and 1.7-2 mm thick Magnets: 5mm x 2 https://s.click.aliexpress.com/e/_DdAP3L9 Instructions: Print the 2 pieces: revo box v29 v4 English revo box v29 v4 Spanish Notes: Be careful when putting the magnets. You must respect the polarity so that they are attracted. I advise you to place 2 magnetically joined magnets (one on top of the other) in each of the 4 holes of one of the pieces, then place the other piece on top and press to get them into their holes. If they go under pressure you will not need glue, and if not, pour a small drop of glue into each magnet. Whether they come in fair or not depends on the setting of your 3D printer. If your printer is well calibrated and you use a nozzle of 0.4mm or less, it should enter tightly but without too much difficulty. Print settings: 0.4 nozzle layer height 0.2 mm No supports print with the part of the letters attached to the bed For this design I used as a basis the magofpv design in thingiverse.com thing:5398216 to which I added the magnets, another symmetrical piece and added the explanatory texts about the size and color of the nozzles and lighted the posters with the sizes. English: In this box you can store 4 Revo nozzles in a small space. The closure is magnetic thanks to the use of 8 small magnets. Instructions: Print the 2 pieces: revo box v29 v4 English revo box v29 v4 Spanish You need to buy 8 magnets size: 5 mm diameter and 1,7 mm thick Notes: Be careful when placing the magnets. You must respect the polarity so that they attract each other. I advise you to place 2 magnetically attached magnets (one on top of the other) in each of the 4 holes of one of the pieces, then place the other piece on top and press them into their holes. If they fit under pressure you won't need glue, and if not, put a small drop of glue on each magnet. Whether they fit tightly or not depends on the setting of your 3D printer. If your printer is well calibrated and you use a 0.4mm or smaller nozzle, they should fit tightly but without too much difficulty. Printing configuration: 0.4 nozzle layer height 0.2 mm Without supports printing with the lettering part glued to the bed For this design I used as a base the design of magofpv in thingiverse.com thing:5398216 to which I added the magnets , another symmetrical piece and added the explanatory texts about the size and color of the nozzles and aligned the signs with the sizes.