Revised ANYCUBIC Door-Opener

thingiverse

I really liked the overall design of ANYCUBIC's door opener, but found that I was still bumping my fingers against the handles at work due to the short reach of the opener. To fix this issue, I added some length to the original handle, keeping fingers further away from door handles as a result. I also expanded the hole in the back of the handle to fit retractable reels with ID card attachments through it easily. To keep your door openers clean and safe, you'll want to wipe them down regularly with at least 70% alcohol or a 10% bleach solution to prevent any buildup of microbes. It's essential to ensure that you don't end up with under extrusions, as these can create spaces where microbes can hide. One thing to watch out for when printing this design is elephant foot. While most printers should be fine, I've had some issues with glass print beds in the past. However, it's easy enough to sand down the sharp ridge that may form from this on one side of the print.